Processing gear pumping oil spill measures

Reducer oil spills, made the following several actions:

(1) shall be easily removable seal gland structure based;

(2) should be based on the open structure of the main ring;

(3) a reasonable increase back to the hole at the position of the input shaft bearing.

(4) of the reducer housing an aging treatment, so to avoid deformation of the shell, effectively stop the oil spill close box surface at locations along the reducer. At this stage, we often use the natural aging, artificial aging method and VSR law.

(5) To set the corresponding ring tank at the bottom of the machine together reducer box surface, and that there must be between multiple ring tank back to the hole and maintain connectivity. Reducer actual operation, the oil will be flowing into the tank surface together, and then penetrate into the oil and then the entire ring tank, and finally flows into the tank through the back hole, so that the lubricant will not close the box and flow along the surface to slow down the housing body.

(6) in the assembly reducer process, should take appropriate sealant applied to the surface of the box together, so that the position would not have fit the box surface spills happening. This method is feasible for the factory, and in oil field repair process must first prepare the required sealant, otherwise, may not use this method.

(7) In the event there is a higher gear oil level will result in the gear oil stir declining power, resulting in leakage of lubricating oil splashing occurs, while also improving the oil, especially in the summer, due to environmental temperature rose, led to the rise in oil and lubricants do not have the proper viscosity, the original lubricating properties are weakened, resulting in liquidity and the amount of oil leakage further exacerbated gear and bearing lubrication decreases, the actual life is not long . Therefore, we should always pay attention to the oil level reducer, maintain proper.

(8) The gasket is installed as the hole in the lid and put the location of the hole, at the same time, tighten the bolts. The output shaft of the spill port to be increased, thereby effectively preventing the occurrence of oil leakage at the position of the output shaft.